Mold Testing in Port Townsend, WA —
Matched Method, Meaningful Baseline, Written Results

Mold spores are naturally present in outdoor air everywhere — the outdoor concentration varies enormously by season, weather, and regional vegetation, and it's different on a dry fall afternoon than on a humid summer morning in the same Port Townsend location. Without knowing what the outdoor concentration is on the same day as the indoor sample, you can't determine whether the indoor count is elevated relative to background. A count of 500 Cladosporium spores/m³ might be normal if the outdoor count that day is 600, or it might indicate a problem if the outdoor count is 40. The comparison is what produces a finding — not the raw number alone.

ERMI (Environmental Relative Moldiness Index) uses qPCR analysis on settled floor dust to identify and quantify 36 specific mold species. Because settled dust accumulates over time, ERMI reflects the historical mold load in the property — not just what's airborne at the moment of sampling. This makes ERMI appropriate for: properties where current air sampling is normal but past mold events are suspected; post-remediation verification when you want to confirm long-term improvement, not just current-condition clearance; and properties where current airborne counts fluctuate with weather and ventilation in ways that make point-in-time sampling unreliable.

Outdoor baseline, chain of custody, accredited lab, use-case report format, AIHA-method compliance. These five factors separate meaningful testing from results that look official but can't be used for the purpose you need them for.

Minimum for a meaningful result: one outdoor comparative, plus indoor samples at areas of concern and at least one unaffected area. A typical Port Townsend, WA single-family home inspection involves three to five samples total: one outdoor, one to two in suspected problem areas, one in an unaffected area. Larger properties, multi-unit buildings, or commercial properties require samples per zone or unit. We scope the sampling protocol based on your specific property size and what question we're trying to answer — not a default package.

For insurance purposes, mold test results need to: (1) establish that elevated mold conditions exist (indoor-to-outdoor baseline comparison); (2) identify the mold genera/species present; (3) correlate with a covered water event that caused the moisture condition; and (4) be produced by an accredited lab under chain of custody to be credible to the adjuster. Our Port Townsend, WA testing documentation includes all four elements, and the written report is formatted to provide adjusters what they need to evaluate the claim without requesting additional documentation.